CHT Brass nozzle Volcano with Bondtech coating -1 pc. 0.8mm

CHT Brass nozzle Volcano with Bondtech coating -1 pc. 0.8mm

Features

• 1 piece per pack
• Available sizes: 0,40, 0,60, 0,80 mm
• Optimised for 1.75 mm thread
• Compatible with 2.85 mm filament
• Requires 6 mm wrench

Key benefits of Bondtech CHT® Vol

• Greater melting capacity by increasing the surface area of the heating walls
• Increase in flow rate by nearly 50%
• Competitive price/performance
• Made with super precision
• Brass nozzle with nickel coating
• Follows the standard for nozzles: Volcano (M6×1×14,5×21)
• It can be used with 1,75 or 2,85 mm hotends.

The increase in flow may vary. Results depend on the hardware, materials and print settings used.

Advantages of Bondtech CHT® technology:

The Bondtech CHT® nozzles divide the filament into 3 thinner filaments, allowing the material to melt from the inside. In this way the material melts faster and higher flow rates can be used.

Advantages of nickel plating

Nickel plating is applied to our coated brass nozzles to provide protection against corrosion, erosion and abrasion. Nickel coated nozzles are more resistant to corrosion and have a lower coefficient of friction, which allows for smoother material feed and slows plastic sticking to the nozzle surface.

Recommended materials

Use this nozzle with the following materials:

PLA
ABS
HIPS
PC
TPU
TPE
Naylon
PETG
ASA
PP
PVA

For technical and abrasive materials we recommend using other nozzles from our range.

Different nozzle sets for different materials

We recommend that you have several sets of nozzles as:

• The use of different materials with the same nozzles leads to the accumulation of deposits inside the nozzle.
• These deposits will cause clogging.
• We recommend changing nozzles when changing materials.