Water-Wash Resin+ – 1 L. – grey – HD Gray- ANYCUBIC – resin

Water-Wash Resin+ – 1 L. – grey – HD Gray- ANYCUBIC – resin

Product Features:

● It is washable with water and has a light smell

● Low viscosity, fast printing

● High precision and little shrinkage

• No alcohol needed
• Easy to use: easy to clean, 3D parts are rinsed with water instead of alcohol, so you will save time and budget;
• ANYCUBIC Wash and Cure machines are recommended to provide a better effect.
• Low viscosity and fast printing: the low viscosity of the resin means it is more fluid, which helps improve printing speed.
• Do not get cracks: an improved formula has been made to prevent cracking of the patterns. Experimental results in Anycubic’s laboratory prove that the performance of 3d models printed with Anycubic Water-Wash Resin+ are stable and last a long time without cracking.
• Wide Compatibility:365-405nm wide band compatibility, suitable for processing animation, cultural and creative handmade models, detailed models, prototypes, etc.

Resin parameters:

Instructions for use:

• Before use: Shake the resin before use
• Clean the resin tank and moulding platform to keep the bottom of the resin tank clean.
• When using: Unscrew the cap and add it to the resin tank according to the equipment requirements
• Select the correct parameters and settings for printing.
• After use: After printing, please use the corresponding post-processing tools, including blade, diagonal pliers, tweezers, containers, gloves; Ethanol (≥95%), lactate cleaning solution or isopropyl alcohol;
• Post-processing steps: Remove the printed pattern from the moulding platform with a blade; Dip the model in the cleaning solution, rinse or ultrasonic wash, then pick it up Remove and drain;
• ANYCUBlC washing and curing machines are recommended to ensure better effect.
• Proper processing, such as removing support, polishing, staining, etc.

Precautions:

• The ideal storage condition for uncured resin is a cool, dark place at room temperature and protected from light to avoid high temperature or sunlight.
• The suggested operating temperature is 18-35’c
• Low temperature can affect the printing effect, thus the resin can be pre-heated before use (no more than 60°C).
• If the resinous pigment settles, it can be used after stirring or shaking.
• To ensure the effectiveness of the resin, please remove the model in time after cleaning to avoid soaking it in water for a long time.
• To ensure the mechanical properties of the model, please carry out post curing in time after cleaning and drying.
• To ensure the ideal performance of the curing material, it is necessary to control the intensity and timing of the light source after curing. Therefore, the following steps are recommended: The intensity of the mercury lamp or LED light source is 5-10mW/m? and the duration is no more than 1 hour (self-regulating); Sun exposure time (in summer) is about 1 hour; Proximity or long-term exposure to strong light sources, such as powerful high-pressure mercury и lamps is prohibited. It is recommended to print in a dark room or cover with a lid while printing, as the resin is photosensitive material.

Note: Material properties will vary depending on the moulding equipment, post curing method and testing equipment.

Recommended printing parameters: